Hunter-fan 42639-01 User Manual download pdf (Page 6)

3 • Assembling and Hanging the Fan

Steps 3-5 – 3-6

Low Proﬁle Screw

Low Proﬁle Washer

Steps 3-2 – 3-3

Downrod

Canopy

Trim Ring

Set Screw

Step 3-8

U-shaped

Hole

WARNING: Fan may fall if not assembled as directed in these

installation instructions.

3-1. Unbundle the wires from the fan.

For Standard or Angle mounting:

3-2. To assemble fan to hang down from a ﬂat or angled ceiling, insert

the downrod through the canopy and canopy trim ring. Feed the

wires from the fan through the downrod.

3-3. Loosen the square head set screw on the adapter to install the

pipe and ball assembly. Note: When the pipe and ball assembly

is fully installed, 2-3 threads on the pipe will still be visible; this is

normal. Securely retighten the set screw with a wrench or pliers.

Skip to Step 3-7.

CAUTION: e adapter has a special coating on the threads. Do

not remove this coating; the coating prevents the downrod from

unscrewing. Once assembled, do not remove the downrod.

For Low Proﬁle mounting:

Note: For low proﬁle mounting, the downrod is replaced with the low

proﬁle washer.

3-4. Remove the set screw from the adapter.

3-5. Place the low proﬁle washer (lip up) into the canopy. Be sure the

green ground wire is pointing up toward the ceiling.

3-6. Align the holes in the washer with the holes in the adapter.

Assemble securely with three low proﬁle screws.

3-7. Place the upper glass over the fan body. Remove the backing from

the adhesive tape and press the glass into place.

3-8. Raise the fan and place the hook on

the ceiling plate through the U-shaped

hole in the rim.

Hunter Fan Company 42639-01 • 4/5/07

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

Hunter-fan 42639-01 User Manual Page 6